Tube Light Circuit Connection Single Phase Fan Motor

Hello dosto aaj iss video mein ham janenge.

Tube light circuit connection.

Single fluorescent light wire connection. A closed circuit will indicate shunted tombstones. Get more great videos subscribe h. Electronic ballast tube light wiring diagram connection and working we need tube light ballast starter and fluorescent light holders to make wiring connection. 3e determine if your led tube light is compatible with the shunted or non shunted tombstone configuration if your led tube light is single ended it is not compatible with shunted tombstones. The starter is made up of a discharbe bulb with two electrodes next to it.

This video about tube light circuit wiring diagram. The tube light or fluorescent light is a low pressure mercury vapor gas discharge lamp and it uses fluorescent to produce white light. Fluorescent tube light ki wiring connection kaise ki jaati hai. Tube light ke parts jaise fluorescent tube light. This principle of the choke is exploited in lighting a fluorescent tube light. The fluorescent tube has two filaments with four terminals the starter is connected between two filaments the ballast is connected between main ac.

Double tube light क connection क स क य ज त ह इस video म circuit diagram बन कर द ख य और बत य गय ह. In a shunted tombstone however this is not possible as there will be an internal short circuit. This is because each of the two contacts in the tombstone must be opposite polarity for a single ended led tube light to work. Tube light is a lamp that works on low pres. What is tube light. This creates light however the heat from the bulb causes.

In this video i will show you fluorescent tube light wiring connection and also provide circuit diagram of connection. When an ac voltage is applied to a tube light fixture the voltage passes through the choke the starter and the filaments of the tube. When electricity passes through it an electrical arc is created between the two electrodes. Tube light wiring diagram. At the same time when the starter opened the circuit path of two filaments from series connected then the ballast release its stored voltage. When we connect the ac supply voltage to the circuit then the starter act like short circuited and current flow through those filament located at the first and second end of the tube light and the filament generate heat and it ionized the gas mercury vapor in the fluorescent tube lamp.

The filaments light up and instantly warm up the tube.